If you’re going to have your mill mobile I totally agree, but mine is bolted to the floor I have the space
Bill From: [email protected] [mailto:[email protected]] Sent: Monday, 9 February 2015 3:49 PM To: [email protected] Subject: Re: enlarging turning capacity of a legacy also wanted to mention that an important aspect in lengthening and widening this mill was the base and it's inherent strength and how rigid it is...i would strongly suggest to any mill owner to build a base for their machine, regardless of what length it is... and if made properly, you will never experience any twist or flex to your mill, even on an uneven floor...the floors in our shop are very uneven(in one corner we are out of level by 12"!!!) and there are times when we move the mill, that one of the four wheels on the base will be off the floor, due to the floor being out of level...the base will not flex to meet the floor...this provides a very high confidence level that when reassembling the mill, as good a tolerance level as possible can be had, even as good as before the mill was extended and widened...something i wanted to put out there and something i think a mill owner should consider doing...joe -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
