well, a couple of comments from someone who has "been there and done that"...i also agree that grease and sawdust are a very bad combo and would not go in that direction...i also studied bernie's set up prior to doing mine and the carriage assembly could jump upward a bit...granted, it would take a lot to do that, but the possibility still exists...and this set up could not work on the "Y" axis...and in regards to tim's comment, the bearings i used, when i converted all three axis', is of a "V" design,but reversed...the rail is of a "V" configuration/design with the bearings riding inside the "V"
-- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
