That's not bad Bill, Nice find. The Lap joint is easy to make. but this method dose take up a bunch of time to do. There is almost always, a 1001 ways to do anything. Its just some ways are better then others, depending on the job needing to be done at the time. Thanks Bill. C.A.G p.s. That's two for this month. ;-)
----- Original Message ----- From: "Bill Bulkeley" <bulke...@mmnet.com.au> To: legacy-ornamental-mills@googlegroups.com Sent: Thursday, September 1, 2016 5:58:25 PM Subject: lap joints Browsing legacy’s web site I found this on tips and techniques’. Do you all think it could be done on our manual mills? Any ideas how? http://www.legacycncwoodworking.com/legacy-tips-techniques/ Bill -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com . To post to this group, send email to legacy-ornamental-mills@googlegroups.com . Visit this group at https://groups.google.com/group/legacy-ornamental-mills . For more options, visit https://groups.google.com/d/optout . -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
