Hi Bill Yes, not with lap joints but with the same result using staggered segmented rings liked in making a segmented bowls. Ron In a message dated 9/1/2016 5:58:43 P.M. Eastern Daylight Time, bulke...@mmnet.com.au writes:
Browsing legacy’s web site I found this on ti ps and techniques’. Do you all think it could be done on our manual mills? Any ideas how? http://www.legacycncwoodworking.com/legacy-tips-techniques/ Bill -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to _legacy-ornamental-mills+unsubscribe@googlegroups.com_ (mailto:legacy-ornamental-mills+unsubscr...@googlegroups.com) . To post to this group, send email to _legacy-ornamental-mills@googlegroups.com_ (mailto:legacy-ornamental-mills@googlegroups.com) . Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
