Very Nice Curtis
Here is yet another way to use those magnetic sheets. cut them into
small pie shaped pieces about 3/4 long. Do a hole count and place the
point of the pie at each hole you will be using. That way, after the
first time you count, each hole will be already marked and ready for the
next run.
Mike OK
On 10/2/2016 12:47 PM, CURTIS GEORGE wrote:
Hello Everyone.
I know and do like to use Mikes gear indexing method, it works very
well for complex/numbers of cuts. But for simple indexing.
This is another method that I like to use.
Its easy and to the point.(excuse the pun) What you see is what you
get, type of method.
I had these disks cut form me, I wedge them between the indexing plate
and the screw that hold the plate onto the legacy's head-stock. with
out any troubles you can see the holes from indexing plate, there is
no counting of holes just, unlock the indexing pin and adjust the
plate to the edge to the plastic stencil .
ON the indexing methods 2. I found out that the magnetic dryer vent
covers do a very good job, they stick to the steel, can be locked into
place and do not move unless you remove them. The best part with this
is, the sheets are cheep to buy and easy to cut with a pair of
scissors. (the price for these sheets were under $5.00 for the pack.)
so they offer a cheap and effective method of indexing that is the
same but different method. The old saying goes, "there is always
more then one way to skin a cat". Here are two examples Of how to do
the same thing, differently. ;-)
C.A.G.
--
You received this message because you are subscribed to the Google
Groups "Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to legacy-ornamental-mills+unsubscr...@googlegroups.com
<mailto:legacy-ornamental-mills+unsubscr...@googlegroups.com>.
To post to this group, send email to
legacy-ornamental-mills@googlegroups.com
<mailto:legacy-ornamental-mills@googlegroups.com>.
Visit this group at
https://groups.google.com/group/legacy-ornamental-mills.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups "Legacy
Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to legacy-ornamental-mills+unsubscr...@googlegroups.com.
To post to this group, send email to legacy-ornamental-mills@googlegroups.com.
Visit this group at https://groups.google.com/group/legacy-ornamental-mills.
For more options, visit https://groups.google.com/d/optout.
