Here is something from my country you might be able to make something similar
http://www.woodfast.com.au/index.php?p=1_11 Bill From: legacy-ornamental-mills@googlegroups.com [mailto:legacy-ornamental-mills@googlegroups.com] On Behalf Of Richard Ellis Sent: Thursday, 22 December 2016 10:17 PM To: Legacy Ornamental Mills Subject: Re: Miniature spindles The Shopsmith duplicator looks a good idea ------but and a big BUT how do you keep the hand held unit at 90 deg to the work and also the pattern,, Is it the case of keeping it square by eye. If that is the case I am sure I can make a similar copier to go on my Record lathe.. Richard On Wednesday, December 21, 2016 at 3:37:09 PM UTC, Richard Ellis wrote: My son-in-law asked me if I could get these small spindles made 10 required Approx Dia. 1/2" by 1"long with a dowel at each end 1/4" Dia by 1/4" long A bit on the small side for the Woodchuck !!! Tried on my Record lathe and could not get two the same, I did however get a good dose of backache -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
