I use primarily round over bits. -Tim
Sent from BlueMail On May 15, 2017, 1:04 AM, at 1:04 AM, Richard Ellis <rchrd.ell...@gmail.com> wrote: >Hi Everyone, >Well, yesterday I needed quite a few blanks for testing out wave >patterns >on the Revo, using what limited cutters that I have. >So went to the old Woodchuck using some rubbish pine wood, put a half >inch >spiral up-cut Milling cutter into the ER 20 collet extension . >Set the limit switches, set the speed on the drive to the spindle. >Don't >trust the limit switches too much.!!!??? >Two inch square blanks, two passes and a fairly clean cut surface. >Nice >not to crank handles all day---------- just stand back and when near >the >end of the cuts, just make sure the switches work. >Today I will use the Woodchuck again to prepare , size and taper the >Dia.for the Revo for testing what cutters I have . >I must think about limit switches and a drive for the spindle for the >Revo. >More expense !! >What cutters are you folk using for Wave Patterns ? >Richard > >-- >You received this message because you are subscribed to the Google >Groups "Legacy Ornamental Mills" group. >To unsubscribe from this group and stop receiving emails from it, send >an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. >To post to this group, send email to >legacy-ornamental-mills@googlegroups.com. >Visit this group at >https://groups.google.com/group/legacy-ornamental-mills. >For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
