I would do it on the spindle with the indexing gear using a square off the rails to check it.
But I’m guessing I usually square all my stock on the table saw. Bill From: legacy-ornamental-mills@googlegroups.com <legacy-ornamental-mills@googlegroups.com> On Behalf Of Richard Ellis Sent: Tuesday, 23 June 2020 2:19 AM To: Legacy Ornamental Mills <legacy-ornamental-mills@googlegroups.com> Subject: Box making I am making some small boxes 4x8 inch 4 inch deep. I have done all the box joints using 1/2 inc cutter, Four turns with the handle worked well. Now glue up ----------I have block of wood 3 1/2 inch but not quite square. The question is how to make it square on the Legacy---45 180 90 or planing on the table, Table will get two sides o.k. but how about the others. The block is for clamping, one corner off for glue run out. Richard -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com <mailto:legacy-ornamental-mills+unsubscr...@googlegroups.com> . To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/d24ef8bb-507b-43d4-a149-028046c80fd1o%40googlegroups.com <https://groups.google.com/d/msgid/legacy-ornamental-mills/d24ef8bb-507b-43d4-a149-028046c80fd1o%40googlegroups.com?utm_medium=email&utm_source=footer> . -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/000201d648be%24b82cacd0%2428860670%24%40mmnet.com.au.