Date: Thu, 19 Jan 2006 13:35:31 +0000 (UTC)
From: [EMAIL PROTECTED]
Subject: Re: [LIB] donauboe fir, acpi, and kernel 2.6
you may want to check out the acpi source. If remember right, acpi was not
handling chip power on right. there is a modified for bluetooth. it may
work. I finally gave up since I have a u100 now.
john
On Thu, 19 Jan 2006, Richard Mittendorfer wrote:
Date: Thu, 19 Jan 2006 18:29:00 +0100
From: Richard Mittendorfer <[EMAIL PROTECTED]>
Subject: Re: [LIB] donauboe fir, acpi, and kernel 2.6
Also sprach [EMAIL PROTECTED] (Thu, 19 Jan 2006 09:01:28 -0800):
Date: Thu, 19 Jan 2006 08:38:19 -0800 (PST)
From: [EMAIL PROTECTED]
Subject: Re: [LIB] donauboe fir, acpi, and kernel 2.6
I finally made up two boot entries, one that used acpi and one that
used apm since it works under apm them rebooted when I need irda
otherwise left it off.
I see. Thx for this info - I'll consider this. However, ACPI is somewhat
useful. I've now loaded a edited DSTD (ACPI-Table) -- unfortunately
without effect.
I think I'll bother the people on the irda-ML a little bit. I hope they
have an workaround or idea about this - I don't want to loose ACPI. :)
I'll message if I find something.
THX, ritch
Date: Thu, 19 Jan 2006 10:00:50 +0100
From: Richard Mittendorfer <[EMAIL PROTECTED]>
Subject: Re: [LIB] donauboe fir, acpi, and kernel 2.6
John Musielewicz wrote:
for some reason I can not get the fir donauboe driver
to load without and error -16 (cannot find location of
the i/o base 0xffe0) when I load linux kernel 2.6.x.x
NET: Registered protocol family 23
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
ACPI: PCI Interrupt 0000:00:11.0[A] -> Link [LNKC] -> GSI 11 (level,
low) -> IRQ 11
toshoboe: can't get iobase of 0xffe0
donauboe: probe of 0000:00:11.0 failed with error -16
Have you got around this? I'm currently having exact the same
trouble with 2.6.15-ck1 (tried various of them).
sl ritch
