Hi John:
Actually I didn't mean to enable EARLY_PRINTK in .config. Actually
I only used the android_omap3_defconfig, and I found I can not see the
terminal messages so I tried to enable EARLY_PRINTK to see if there're
any suspicious.
The last line I can see is:
Uncompressing Linux... done, booting the kernel.
Any clue on this for me?
Regards,
-Jeremy
On Wed, Mar 2, 2011 at 3:30 PM, John Stultz <[email protected]> wrote:
> On Tue, 2011-03-01 at 23:17 -0800, John Stultz wrote:
>> On Wed, 2011-03-02 at 14:23 +0800, Jeremy Chang wrote:
>> > Hi, John:
>> > I have one question about the origin/dev/linaro.android branch
>> > right now for beagleboard xM.
>> > After tried, I still can not see the terminal log after the "Virtual
>> > kernel memory layout" message with EARLY_PRINTK enabled., even printk
>> > messages in omap3_beagle_init() can not be seen.
>> > I see With 2.6.36/37+: the console should be changed to
>> > 'ttyO2,115200n8' in u-boot. but the problem still exists for me.
>> > Could you give some clue for me how to solve this?
>>
>> Huh. I'm not sure if I've played with early printk on beagle.
>>
>> If not, mind sending me the .config you're using and I'll take a look?
>
> Oops, sorry, that second line was confusing. I was initially going to
> ask if you were using the android_omap3_defconfig, but clearly that's
> not the case as EARLY_PRINTK isn't enabled there.
>
> So do please send your config.
>
> thanks
> -john
>
>
>
_______________________________________________
linaro-dev mailing list
[email protected]
http://lists.linaro.org/mailman/listinfo/linaro-dev