On Thu, Nov 29, 2012 at 9:40 AM, "L. Alberto Giménez" <[email protected]> wrote: > El 29/11/2012 7:54, Stefan Hajnoczi escribió: > >> >> Is the device plugged into a USB 2.0 port? >> > > It's connected to an external hub. I don't know if that's the reason of > lsusb not showing endpoints, but when I connect the device I get this > message: > > > [ 333.697431] usb 1-2.4: new full-speed USB device number 4 using ohci_hcd > [ 333.795169] usb 1-2.4: not running at top speed; connect to a high speed > hub > > I didn't know that would alter the number of endpoints that the device shows > to the system. > > I use a hub just because it's easier to me to reach the hub on my desk with > the USB cable than the rear of my computer, but I can try to connect > directly to the root hub and see if I see any changes.
Does it work under Windows through your hub? Stefan ------------------------------------------------------------------------------ Keep yourself connected to Go Parallel: VERIFY Test and improve your parallel project with help from experts and peers. http://goparallel.sourceforge.net _______________________________________________ Line6linux-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/line6linux-devel
