Well, it's not like there are _any_ supported platforms for Slack/390, unless you're willing to spend some money. I'm putting this out largely so that people don't have to spend money. LPAR mode and z/VM I know from personal experience, and can usually answer questions about them.
Since this is really a Hercules questions, I would suggest posting it to the Hercules mailing list. Those guys have been dealing with Linux/390 in that environment for quite a while now. It's entirely possible this has been dealt with many times before. If they do have the answer, I'd appreciate a pointer to it (if it's in their archives) being posted here, or an explanation if it is not in their archives. Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Richard Pinion Sent: Tuesday, September 28, 2004 8:37 AM To: [EMAIL PROTECTED] Subject: Re: 3270 console in Slack390 9.1 Now how did you know I was using Hercules. In Hercules one starts a TN3270 session using the IP address of the PC that is running Hercules and specifies port 3270. I'm doing this but I'm not getting anything. It sounds like Hercules is not a supported platform so maybe I'll stumble onto the answer. ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
