That's the piece I cant find in the 2.6 kernel device drivers manual is how
to specify the command and where. I read the section on zipl in
SC33-8281-00 and while I see a lot of stuff about SCSI boot and SCSI Dump
stuff, and even boot menu stuff, but alas nothing talking about specifying
DASD on the command line or config file.
Is there a more complete set of documentation on zipl/zipl.conf than the
device drivers features and commands manual ?
"Post, Mark K"
<[EMAIL PROTECTED]
m> To
Sent by: Linux on LINUX-390@VM.MARIST.EDU
390 Port cc
<[EMAIL PROTECTED]
IST.EDU> Subject
Re: SLES9 zipl/mkinitrd question
12/02/2005 03:19
PM
Please respond to
Linux on 390 Port
<[EMAIL PROTECTED]
IST.EDU>
Yes. Put it in the command line entry in /etc/zipl.conf and rebuild
your initrd.
Mark Post
-----Original Message-----
From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of
James Melin
Sent: Friday, December 02, 2005 4:14 PM
To: LINUX-390@VM.MARIST.EDU
Subject: SLES9 zipl/mkinitrd question
Is there a way to specify the dasd devices you want the guest to know
about at IPL like there was in SLES8?
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
