If you cut and pasted this, as opposed to typing it in, I see a problem. Your Gateway specification has 6 octets instead of 4. I don't know if this would mess up the parsing of the Hostname or not, but it might.
Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Marian Gasparovic Sent: Saturday, October 28, 2006 3:56 PM To: LINUX-390@VM.MARIST.EDU Subject: Re: sles10 hostname ramdisk_size=65536 root=/dev/ram1 ro init=/linuxrc TERM=dumb HostIP=129.40.178.130 Hostname=lat130.pbm.ihost.com Gateway=129.40.178.254.178.254 Netmask=255.255.255.0 Broadcast=129.40.178.255 Layer2=0 ReadChannel=0.0.0600 WriteChannel=0.0.0601 DataChannel=0.0.0602 Nameserver=129.40.106.1 Portname=dontcare Install=nfs://129.40.46.206/nfs/sles10/CD1 UseVNC=1 VNCPassword=123456 InstNetDev=osa OsaInterface=qdio OsaMedium=eth Manual=0 Everything is used correctly, vncserver starts, I connect there, set partitions, choose software, start install. After all needed files from CD1 are read, system is rebooted, then rest of files are read and then it asks for hostname and domain. So I don't enter any of these parameters anywhere during install, only hostname --- "Post, Mark K" <[EMAIL PROTECTED]> wrote: > Marian, > > Could you show your whole parmfile? I might be able > to take a look at > it. > > > Mark Post > > -----Original Message----- > From: Linux on 390 Port > [mailto:[EMAIL PROTECTED] On Behalf Of > Marian Gasparovic > Sent: Friday, October 27, 2006 1:33 PM > To: LINUX-390@VM.MARIST.EDU > Subject: sles10 hostname > > Hello all, > I install SLES10 with parameters in PARMFILE. > Everything works nicely, only Hostname=xxx is not > used, installer asks for it after first reboot. Am I > doing something wrong ? > Thank you > > =================== > Marian Gasparovic > =================== > "The mere thought hadn't even begun to speculate > about the merest > possibility of crossing my mind." > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access > instructions, > send email to [EMAIL PROTECTED] with the > message: INFO LINUX-390 or visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > ________________________________________________________________________ __________________ Check out the New Yahoo! Mail - Fire up a more powerful email and get things done faster. (http://advision.webevents.yahoo.com/mailbeta) ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390