Does anyone know if there are any known problems with NPIV and Suse 10 SP2? We're trying to add NPIV to one of our Suse 10 test systems, and having a spectacularly unsuccessful time.
When we turned the NPIV bit on, we lost access to all the fcp dasd that had been working without any problems, so we turned NPIV off on the original channel, and added another channel; all the defined fcp devices started working again, and then we turned NPIV on for the new channel. VM can see the new channel and the addresses that have been dedicated to the Suse test system. Suse can see the channel, and reports the following during boot: scsi3 : zfcp zfcp: The adapter 0.0.f101 reported the following characteristics: WWNN 0x5005076400c36e0d, WWPN 0xc05076fd6b000784, S_ID 0x00701401, adapter version 0x4, LIC version 0x70e, FC link speed 4 Gb/s zfcp: Switched fabric fibrechannel network detected at adapter 0.0.f101. However, when we go into yast2, the fcp function cannot (or will not) define a new device on the new NPIV channel address. It sees the channel address when it does the scan during startup (the address shows up in the add a device pulldown box), but most of the time it doesn't seem to like the WWPN, and we've tried every WWPN we've been able to find that looked like it might work. We can see the channel and the address on the HMC, and the switch. So far, it looks like we can see the NPIV channel where ever we look, but that's about it. Any ideas or suggestions would be helpful. Thank you. Sue Sivets -- Suzanne Sivets Systems Programmer Innovation Data Processing 275 Paterson Ave Little Falls, NJ 07424-1658 973-890-7300 Fax 973-890-7147 ssiv...@fdrinnovation.com ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to lists...@vm.marist.edu with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
