Are you booting the kernel from the bootdisk but using the root as
/dev/hda10?? I am talking about booting using the bootdisk both
kernel and root directory. Do not supply /dev/hda10 as your root
directory to be used, just boot normally as though you have no prior
Linux setup at all. Should boot you using ramdisk (I am not sure, I
have never installed RedHat distro before...)
Then when it boots up, mount your /dev/hda10 to its mount point
(usually /mnt but anything is ok) then go into rc.d and try to clean
up (meaning comment out ANY process or applications that you do not
need to boot up the system - gpm, X, etc...) maybe even getting rid of
modprobe line may help too in case any of your modules are corrupted.
Of course this should be done AFTER you do the file system check in
/dev/hda10..
Then, try to reboot normally to your system. Then, first thing I
would do is to recompile the kernel, to make sure all my modules are
not corrupted, then uncomment 1 application at a time from your init
script. If you can uncomment all the lines without any problem, then
it was corrupted modules, if one of them hangs your system, then you
know which prog is bad, so you can boot with your boot disk again, and
reinstall the package.
Good luck!!!!
______________________________ Reply Separator _________________________________
Subject: Re: Redhat6.1 crashed
Author: "Hong F Du" <[EMAIL PROTECTED]> at INTERNET-MAIL
Date: 7/21/00 12:20 PM
The only Redhat bootdisk that I have is the one created when I first time instal
d
Redhat. Is the one you are saying? I tried that one already, it stopped booting
on the same step while booting. How do I mount /dev/hda10? I cannot see any file
un r
the original linux system, how do I clean up my rc.d? What else can I do?
Help........please.
feng
[EMAIL PROTECTED] wrote:
> Use your RedHat bootdisk with kernels AND file system on them then
> mount your /dev/hda10 (did I see that right? 10??) into a mounting
> point (I do not remember whether you need to mount in order to do file
> system check, you may not need to) and maybe clean up your rc.d to
> boot. Run minimum amount of devices as you need (hdparm, gpm, etc..)
> and if you run X, just make it not to start X and then try rebooting
> the system.. Always, backup backup backup!!.. :)
>
> Good luck!!!!
>
>
> ______________________________ Reply Separator
_________________________________ > Subject: Redhat6.1 crashed
> Author: "Hong F Du" <[EMAIL PROTECTED]> at INTERNET-MAIL
> Date: 7/21/00 10:45 AM
>
> Hi All,
>
> I was working my problem of "cannot change permission on mountable
> drive" (see previous mails), and accidentally killing a process.
>
> When I reboot, the boot processing went through checking root file
> system, /dev/hda10 clean check, setting up ISA PNP devices, and after
> Remounting root file system in read-write mode it stopped there and
> couldn't go further. I used a floppy to boot. It did the same things and
> stopped there.
>
> I don't know what to do to rescue my system. I cannot any file under
> linux file system to go the log files. Please tell me what to do. Any
> suggestion will greatly appreciated.
>
> feng
