On Wed, Apr 18, 2001 at 10:38:56PM +1000, Mr Daniel Marr wrote:
> I am trying to communicate with Angel on the ARM7TDMI by hyperterminal.
> Most of the initial greeting comes up correctly on reset but the
> command prompt is garbled and I can't communicate with it.
> Any Ideas?
Could be incorrect serial port settings. Use 8 databits, no parity, 1
stop bit. I've seen a couple of times that even that didn't help with
hyperterm, and I suppose that's because of the general brokeness of
*cough* Windows.
Erik
--
J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department
of Electrical Engineering, Faculty of Information Technology and Systems,
Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands
Phone: +31-15-2783635 Fax: +31-15-2781843 Email: [EMAIL PROTECTED]
WWW: http://www-ict.its.tudelft.nl/~erik/
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
