Copy Paste from Section 8.2 in the Intel � StrongARM * SA-1110 Microprocessor 
Developer's Manual

The core clock frequency is configured by software through the core clock 
configuration field
(CCF 4:0) in the power manager phase-locked loop (PLL) configuration register (PPCR). 
This
field should be programmed during the boot sequence for the desired full-speed 
operation.
nRESET clears the field by selecting the lowest frequency operation.
See Section 9.5, "Power Manager" on page 9-26 for the physical address used to access 
this
register.
Table 8-1 shows the core clock frequency as a function of the CCF setting.
The actual core clock (DCLK) can switch between being driven by the high speed core 
clock
(CCLK, set by CCF 4:0) and the memory clock (MCLK), which runs at half the frequency of
CCLK. CCLK is used except when the SA-1110 is waiting for fills to complete after a 
cache miss.
Table 8-1. Core Clock Configurations
CCF 4:0 Core Clock Frequency in MHz

      3.6864-MHz Crystal Oscillator 3.5795-MHz Crystal Oscillator
00000 59.0                          57.3
00001 73.7                          71.6
00010 88.5                          85.9
00011 103.2                         100.2
00100 118.0                         114.5
00101 132.7                         128.9
00110 147.5                         143.2
00111 162.2                         157.5
01000 176.9                         171.8
01001 191.7                         186.1
01010 206.4                         200.5
01011 221.2                         214.8
01100- 11111 Not supported. -

The actual core clock (DCLK) can switch between being driven by the high speed core 
clock
(CCLK, set by CCF 4:0) and the memory clock (MCLK), which runs at half the frequency of
CCLK. CCLK is used except when the SA-1110 is waiting for fills to complete after a 
cache miss.

/Benny

-----Original Message-----
From: Zhao Bingqi-w19411 [mailto:[EMAIL PROTECTED]]
Sent: Friday, September 21, 2001 4:46 PM
To: '[EMAIL PROTECTED]'; 'Russell King - ARM Linux'
Cc: [EMAIL PROTECTED]
Subject: How to Change CPU from 206MHz to 133MHz?


Hello   dear  all :

        I  want  to  change  CPU  from  206MHz  to  133MHz.

How  to  do?

I  must  modify  some  source  code ?
And  where ?


Thanks

Best  Regards.

Tim  Zhao.

_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.

_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.

Reply via email to