On Tue, 13 Nov 2001, Philip Jones wrote: > I was wondering if anyone could explain to me how to properly communicate > with a UDA1341TS CODEC via Serial Port 4 on an SA-1110 board, mainly how to > set up the uart and how to properly select which data format I need to set > the CODEC to. I have the UDA1341 being properly (to the best of my knowledge) > set up for operation, and I can see the data going in over the serial port on > my scope, but I get no output from the chip. The only indication that I have > that anything is happening is a small amount of barely audible noise (a buzz) > on the speaker when the chip is turned on to play sound.
Your Ser4SSCR0 register contains a wrong clock divisor. Nicolas _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm Please visit the above address for information on this list.
