On Thu, Mar 07, 2002 at 05:46:54PM +0800, friend Hsu wrote: > I have ever used the blob-1.0.8-pre2 with assabet and > it is working OK. > When I using blob-2.0.5-pre2, the problem that I > mentioned yesterday occur. > Could you tell me why?
I already told you a couple of possible causes. I can't investigate from a large distance, you'll have to do that yourself. > Is it a good ideal that I use blob-1.0.8-pre2 with > kernel-2.4.1? Both blob-1.0.8-pre2 and linux-2.4.1 are over a year old. In that year many bugs were fixed, and many new kernels and blob versions were released. If you choose to run software with known bugs that's fine with me, but don't expect people to help you. I am interested in your blob-2.0.5-pre2 problem, but you'll have to investigate the possible causes yourself. Erik > --- Erik Mouw <[EMAIL PROTECTED]> ???T???G> On > Wed, Mar 06, 2002 at 05:53:31PM +0800, friend Hsu > > wrote: > > > I compiled "blob-2.0.5-pre2" and downloaded "blob" > > > into my assabet. > > > After re-power-on the assabet. > > > There is nothing displayed on my PC's "minicom" > > > screen. > > > I checked the LED which is connected to GPIO17. > > > The LED turns on around 2.5 sec then turns off > > around > > > 2.5 sec and repeat 5 times. > > > What this means? > > > > Prefetch abort, shouldn't happen. Possible causes: > > - Flashing went wrong > > - Configured for something else than Assabet (so > > memory setup is wrong) > > - Not a revision 5 Assabet > > - Something terribly wrong with your DRAM -- J.A.K. (Erik) Mouw, Information and Communication Theory Group, Faculty of Information Technology and Systems, Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands Phone: +31-15-2783635 Fax: +31-15-2781843 Email: [EMAIL PROTECTED] WWW: http://www-ict.its.tudelft.nl/~erik/ _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm http://www.arm.linux.org.uk/armlinux/mailinglists.php Please visit the above addresses for information on this list.
