Hi,
I'm having fun getting the Tulip 21143 ethernet chip to work with an
Integrator/AP board. Seems I can kick start the transmission of the setup
frame, but it sets the first word of my TDESC area to 0x7fffffff (using bus
master of PCI) which looks wrong to me. After that, it refuses to transmit
anything, just saying that the transmit descriptor not available, even if I
set TDESC0 to 0x80000000 again.
Has anyone had this going? Anything I should know? Any problems with PCI on
Integrator?
Regards,
Simon
--
Bluewater Systems Ltd - ARM Technology Specialists
Simon Glass Bluewater Systems Ltd
Phone: +64 3 3779127 Level 17, 119 Armagh St
Fax: +64 3 3779135 PO Box 13889
Email: [EMAIL PROTECTED] Christchurch
Web: http://www.bluewaternz.com New Zealand
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
http://www.arm.linux.org.uk/armlinux/mailinglists.php
Please visit the above addresses for information on this list.
