try adding the following line to your lilo.conf:
append="mem=256M"
run lilo, then reboot
hope it helps
Camelia N.
Dave Millen wrote:
>
> Hi,
>
> I'm not sure if this is a config problem or a kernel problem, please let
> me know if this is the wrong list.
>
> I have installed RH 6.0 on a P3 450 with a TMC T16NBF+ motherboard (VIA
> 82C693 Apollo Pro Plus chipset) with 256MB ram.
>
> All 256 MB are found in the startup messages and are also found by
> windows running on the same machine.
>
> Linux only sees 64MB :(
>
> I have tried all possible combinations of dimm and slot and when I, as a
> check, started the same machine with a single 32MB dimm, the memory was
> correctly reported, but any combination > 64MB only shows as 64MB.
>
> Is there anything I should set in my kernel configuration to enable
> large memory models? I don't recall this problem on a Dell Power Edge
> with 256MB.
>
> TIA,
> Dave
> --
> He was part of my dream, of course -- but then I was part of his dream
> too.
> -- Lewis Carroll
>
> email: [EMAIL PROTECTED]
> web: www.largesalad.co.uk/DJMsoft
--
Camelia Nastase
[EMAIL PROTECTED]
