I have had success with the rpm's from redhat (or mirrors).
The rpms you need to get diald running on Red Hat 5.1 are:
ftp://ftp.redhat.com/pub/contrib/i386/diald-0.16.4-1.i386.rpm
ftp://ftp.redhat.com/pub/contrib/noarch/diald-config-1.2.1-1.noarch.rpm
you will also need one of either:
ftp://ftp.redhat.com/pub/contrib/noarch/diald-config-metered-0.2-2.noarch.rpm
ftp://ftp.redhat.com/pub/contrib/noarch/diald-config-unmetered-0.2-2-noarch.rpm
do NOT get the diald-config in the i386 subdirectory - it is old and hosed.
these are binaries and you will not need to compile.
Hope this helps,
Simon Hill
Radoslav Bali-Jencik wrote:
> I compile new diald 0.16.5 on RH 5.1, I was succesfull, but when I start
> diald, fisrt time modem connect to my cisco, but after disconnecting
> second time chat did not finished and I can't do 'reboot'.I can see in
> messages that chat is doing another step (expect OK) but in real modem
> start ringing,and connect to remote site. I'm using chat from ppp 2.3.5
> package, which I kompiled. Is there some bug in chat, or is it bad diald?
> Could I rather use older diald from package RPM?
>
> Radoslav Bali-Jencik IN4VENT Plus s.r.o. Michalovce
> e-mail: <[EMAIL PROTECTED]>
> tel: ++421-946-443490
> fax: ++421-946-433499
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-diald" in
> the body of a message to [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-diald" in
the body of a message to [EMAIL PROTECTED]
