You cannot use drbd in heartbeat the way you configured it. Please refer to http://wiki.linux-ha.org/DRBD/HowTov2 and (if that wasn't made clear enough on the page) make sure the first thing you do is upgrade your cluster software. Read here on how to do that: http://clusterlabs.org/wiki/Install
Regards Dominik Heiko Schellhorn wrote: > Hi > > I installed drbd (8.0.14) together with heartbeat (2.0.8) on a Gentoo-system. > > I have following problem: > Standalone the drbd resource works perfectly. I can mount/unmount it > alternate > on both nodes. Reading/writing works and /proc/drbd looks fine. > > But when I start heartbeat it degrades the resource step by step until it's > marked as unconfigured. An excerpt of the logfile is attached. > Heartbeat itself starts up and runs. Two of the three resources configured up > to now are also working. Only drbd shows problems. (See the file > crm_mon-out) > > I don't think it's a problem of communication between the nodes because drbd > is working standalone and e.g. the IPaddr2 resource is also working within > heartbeat. > I also tried several heartbeat-configurations. First I defined the resources > as single resources and then I combined the resources to a resource group. > There was no difference. > > Has someone seen such an issue before? Any ideas ? > I didn't find anything helpful in the list archive. > > If you need more informations I can provide a complete log and the config. > > Thanks > > Heiko > > > > ------------------------------------------------------------------------ > > _______________________________________________ > Linux-HA mailing list > Linux-HA@lists.linux-ha.org > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems _______________________________________________ Linux-HA mailing list Linux-HA@lists.linux-ha.org http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
