Hello,
I'am trying to make a dos machine with BPQ to talk with linux via ax25
and ethernet.
By reading ax25-howto the bpq device is associated with eth0
With "# /sbin/ifconfig bpq0 hw ax25 pi4cc-7 comment" I do config the
eth0 device.
When I start calling pi4cc-7 at the dos machine the packets a received
at eth0. The rx pactkets is counting. But there will be no link. The
bpq0 doen't receive any packet.
My question: whats wrong?
Here is a copy of ifconfig:
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:1657 errors:0 dropped:0 overruns:0 frame:0
TX packets:1657 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
eth0 Link encap:Ethernet HWaddr 52:54:4C:02:EB:50
inet addr:10.0.0.0 Bcast:10.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:30 errors:0 dropped:0 overruns:0 frame:0
TX packets:150 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
Interrupt:5 Base address:0x300
bpq0 Link encap:AMPR AX.25 HWaddr PI4CC-7
inet addr:192.168.0.1 Mask:255.255.255.0
UP RUNNING MTU:256 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
ax0 Link encap:AMPR AX.25 HWaddr PI4CC
inet addr:192.168.0.1 Mask:255.255.255.0
UP RUNNING MTU:255 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
73 peter
PB0AIU
