[PATCH] pata_pdc202xx_old: fix data corruption and other problems
Fix wrong "port" calculations in pdc202xx_configure_piomode()
and pdc202xx_set_dmamode(), it was horribly broken which resulted
in major havoc on all configurations except one (master device on
primary channel, no other devices) as code was writing PIO/DMA
timings and device settings to wrong registers (including
reserved ones),
ap->port_no / ap->devno / used regs / correct regs:
0 0 0x60-0x62 0x60-0x62
0 1 0x62-0x64 0x64-0x66
1 0 0x64-0x66 0x68-0x6a
1 1 0x66-0x68 0x6c-0x6e
Also forward port recent fixes from drivers/ide pdc202xx_old driver:
* fix XFER_MW_DMA0 timings (they were overclocked, use the official ones)
* fix bitmasks for clearing bits of register B:
- when programming DMA mode bit 0x10 of register B was cleared which
resulted in overclocked PIO timing setting (iff PIO0 was used)
- when programming PIO mode bits 0x18 weren't cleared so suboptimal
timings were used for PIO1-4 if PIO0 was previously set (bit 0x10)
and for PIO0/3/4 if PIO1/2 was previously set (bit 0x08)
and finally bump driver version.
Signed-off-by: Bartlomiej Zolnierkiewicz <[EMAIL PROTECTED]>
---
drivers/ata/pata_pdc202xx_old.c | 22 ++++++++++++++--------
1 file changed, 14 insertions(+), 8 deletions(-)
Index: b/drivers/ata/pata_pdc202xx_old.c
===================================================================
--- a/drivers/ata/pata_pdc202xx_old.c
+++ b/drivers/ata/pata_pdc202xx_old.c
@@ -2,13 +2,14 @@
* pata_pdc202xx_old.c - Promise PDC202xx PATA for new ATA layer
* (C) 2005 Red Hat Inc
* Alan Cox <[EMAIL PROTECTED]>
+ * (C) 2007 Bartlomiej Zolnierkiewicz
*
* Based in part on linux/drivers/ide/pci/pdc202xx_old.c
*
* First cut with LBA48/ATAPI
*
* TODO:
- * Channel interlock/reset on both required ?
+ * Channel interlock/reset on both required
*/
#include <linux/kernel.h>
@@ -21,7 +22,7 @@
#include <linux/libata.h>
#define DRV_NAME "pata_pdc202xx_old"
-#define DRV_VERSION "0.3.0"
+#define DRV_VERSION "0.4.0"
/**
* pdc2024x_pre_reset - probe begin
@@ -76,7 +77,7 @@ static void pdc2026x_error_handler(struc
static void pdc202xx_configure_piomode(struct ata_port *ap, struct ata_device
*adev, int pio)
{
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
- int port = 0x60 + 4 * ap->port_no + 2 * adev->devno;
+ int port = 0x60 + 8 * ap->port_no + 4 * adev->devno;
static u16 pio_timing[5] = {
0x0913, 0x050C , 0x0308, 0x0206, 0x0104
};
@@ -85,7 +86,7 @@ static void pdc202xx_configure_piomode(s
pci_read_config_byte(pdev, port, &r_ap);
pci_read_config_byte(pdev, port + 1, &r_bp);
r_ap &= ~0x3F; /* Preserve ERRDY_EN, SYNC_IN */
- r_bp &= ~0x07;
+ r_bp &= ~0x1F;
r_ap |= (pio_timing[pio] >> 8);
r_bp |= (pio_timing[pio] & 0xFF);
@@ -123,7 +124,7 @@ static void pdc202xx_set_piomode(struct
static void pdc202xx_set_dmamode(struct ata_port *ap, struct ata_device *adev)
{
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
- int port = 0x60 + 4 * ap->port_no + 2 * adev->devno;
+ int port = 0x60 + 8 * ap->port_no + 4 * adev->devno;
static u8 udma_timing[6][2] = {
{ 0x60, 0x03 }, /* 33 Mhz Clock */
{ 0x40, 0x02 },
@@ -132,12 +133,17 @@ static void pdc202xx_set_dmamode(struct
{ 0x20, 0x01 },
{ 0x20, 0x01 }
};
+ static u8 mdma_timing[3][2] = {
+ { 0x60, 0x03 },
+ { 0x60, 0x04 },
+ { 0xe0, 0x0f },
+ };
u8 r_bp, r_cp;
pci_read_config_byte(pdev, port + 1, &r_bp);
pci_read_config_byte(pdev, port + 2, &r_cp);
- r_bp &= ~0xF0;
+ r_bp &= ~0xE0;
r_cp &= ~0x0F;
if (adev->dma_mode >= XFER_UDMA_0) {
@@ -147,8 +153,8 @@ static void pdc202xx_set_dmamode(struct
} else {
int speed = adev->dma_mode - XFER_MW_DMA_0;
- r_bp |= 0x60;
- r_cp |= (5 - speed);
+ r_bp |= mdma_timing[speed][0];
+ r_cp |= mdma_timing[speed][1];
}
pci_write_config_byte(pdev, port + 1, r_bp);
pci_write_config_byte(pdev, port + 2, r_cp);
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
