Hi I recently battled with an ALE 070 (similar issues you report), try running the eciadsl-probe-device and then reconfigure using the VID etc., presented for your modem as a result using the eciadsl-config-text.
From the error you show, the firmware is not loaded correctly. The eciadsl-doctor is also useful to diagnose. Hope this helps Good luck Ivor On Saturday 29 October 2005 00:29, Tzafrir Cohen wrote: > On Fri, Oct 28, 2005 at 09:01:36AM +0200, Tzafrir Cohen wrote: > > Hi > > > > Anybody managed to get the ALE 150 USB modem to work under linux? > > > > I tried to follow the documentation from http://eciadsl.flashtux.org/ . > > It seems that the modem was identified and I believe I have managed to > > load the firmware to it. But I can't get it to sync (on the ADSL > > level?). I've already tried quite a few variations. > > > > I'll be there today again to provide more details. But I'd really like > > to know if anybody actually managed to configure it. > > Some more details: the problem seems to be with loading the firmware: > > # eciadsl-firmware -v 0x1690 0x0217 0x1690 0x0217 > # /usr/local/adsl/eciadsl-synch_bin/gs7470_synch04.bin > config: unrecognized entry 'MODEM_CHIPSET' at line 17 > config: unrecognized entry 'SYNCH_ALTIFACE' at line 18 > config: unrecognized entry 'PPPOECI_ALTIFACE' at line 19 > block 1: addr 0x40e1 - length 0: failed > ERROR eciadsl-firmware: failed > eciadsl-firmware: success > > > The system is based on knoppix 3.7 (I do plan to get it in sync with > Debian after I get a decent internet connection, but right now it mainly > functions as a games workstation and I don't want to break that). > > This is from eciadsl-usermode 0.11-beta1 . 0.11 seems to give very > similar results. But I was generaly built for a slightly different libc > than I have installed. > > I have not yet managed to put together a proper build system on that > knoppix, so I use ready-made debs. The three strings from the warnings > above seem to be present in the output of 'strings > /usr/sbin/eciadsl-firmware' ================================================================To unsubscribe, send mail to [EMAIL PROTECTED] with the word "unsubscribe" in the message body, e.g., run the command echo unsubscribe | mail [EMAIL PROTECTED]
