James <[EMAIL PROTECTED]> writes:
> Thanks alot for doing my job (oops feels embarrassed). I'm not really in a
Don't! It took me 5 minutes to fix it since I knew exactly what to do. It
would be a waste of time if you should have tried to figure out which
changes you needed to do with your driver in order to support the new
design.
> position to try anything until next week I'm so far behind I haven't done the
> 2.2 to 2.3 change yet! Is there an up to date FAQ on IrOBEX, or should I
> not be expecting it to work under 2.2 (I keep getting max_sdu == 0 ) ? I've
Sounds correct. OBEX does not use TTP SAR (fragmentation) which means that
the max_sdu must be 0. This tells the sockets interface and TTP that you
want to use a STREAM based service and not a sequenced packet service.
> only just got my permenant internet connection up again after moving house...
> Is 2.3.22-irda3 where I should start?
Maybe, I'm hoping to get these changes into 2.3.23, but pre-2.2.23-6 does
still not contain the changes, so I'm a bit worried. The changes might be
to large for Linus to accept at moment (feature freeze).
-- Dag
--
/ Dag Brattli | The Linux-IrDA Project /
// University of Tromsoe, Norway | Infrared communication for Linux //
/// http://www.cs.uit.no/~dagb | http://www.cs.uit.no/linux-irda/ ///
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www4.pasta.cs.UiT.No/mailman/listinfo/linux-irda
