On Mon, 11 Dec 2000, Luis Falcon wrote:
> The only problem that I run into is the use of the SIR port on the
> IRDA... after compiling the kernel with the NSC option and booting the
> new kernel, it gave me the following error
Compile it as modules.
> Dec 10 16:20:42 inferno kernel: nsc-ircc, Found chip at base=0x02e
> Dec 10 16:20:42 inferno kernel: nsc_ircc_open(), can't get iobase of 0x2f8
The serial driver has claimed 0x2f8 (see /proc/ioports). Use
$ setserial /dev/ttyS1 uart none
Load the nsc-module with the right dongle type:
$ modprobe -a irda ircomm ircomm-tty
$ insmod nsc-ircc dongle=0x09
Start the device:
$ irattach irda0
> Using IRCOMM protocol is not possible to pass the 115kb, right ? If so, I
> don't worry much about SIR....
SIR is only 115k, VIR is 4M. Has nothing to do with ircomm.
BYtE
Philipp
--
/ / (_)__ __ ____ __ Philipp Hahn
/ /__/ / _ \/ // /\ \/ /
/____/_/_//_/\_,_/ /_/\_\ [EMAIL PROTECTED]
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
