Richard B. Johnson writes:
> On Thu, 26 Oct 2000, Albert D. Cahalan wrote:
>> Richard B. Johnson writes:
>>> o Once installed, a kernel module is every bit as "efficient"
>>> as some driver linked into the kernel at build-time. Of course
>>
>> I doubt this is true on most modern processors. On the Pentium
>> and above, large pages are used for the kernel. The PowerPC port
> ^^^^^^^^^^^
>
> The page-size is determined by the architecture.
The page sizes are determined by the architecture.
For common Intel chips: 4 kB, 2 MB, 4 MB.
(some restrictions may apply -- Ingo Molnar would know)
For ia64, you get about a dozen different sizes ranging from
the old 4 kB pages up to something like 256 MB.
For the PowerPC you have BAT registers that override page tables.
You get 4 for code and 4 for data, so you can map all physical
memory for the kernel w/o using page table entries or TLB slots.
The SPARC code, if I recall correctly, does not maintain page
tables for normal kernel code. If the virtual address is within
the direct mapped region, a software TLB loader just adds an
offset to get the physical address.
So your modules suffer by being unable to take advantage of
more efficent virtual-to-physical mapping mechanisms.
>> uses BAT registers. Other ports have other hacks to reduce TLB
>> misses and/or wasted memory. Also, you waste half a page or more
>> for the average module.
>
> Since kernel memory is allocated in pages, you use whatever you
> need. If a module is 4097 bytes in length, you could, in principle,
> 'waste' 4095 bytes. So what? it's never paged or otherwise producing
> any overhead whatsoever.
What, wasted memory is not overhead?
Also, consider the cache effects. To keep things simple, assume
you have a highly modular kernel and that modules are 2 kB.
Also, you have separate 4-way 16 kB L1 caches for code and data.
Well, you now have an 8 kB cache for code, along with 8 kB of
useless transistors.
Of course this is bad, even if you don't have modules that are
exactly 2 kB.
> These are modules I have written for a project. Since these are object
> files, they contain not only code, but also a relocation table. So they
> don't require as much memory as the file size shows. However, since
> these are all modules, the relocation table is similar in size and
> can be considered a constant.
>
> 6204 Oct 24 10:48 firewire.o 8192 - 6204 = 1988
> 11120 Oct 24 10:48 gpib_drvr.o 12288 - 11120 = 1168
> 6692 Oct 24 10:48 ramdisk.o 8192 - 6692 = 1500
> 3886 Oct 24 10:48 rtc_drvr.o 4096 - 3886 = 210
> 6776 Oct 25 12:38 vxibus.o 8192 - 6776 = 1416
> Totals ---- ----
> 34678 6282
>
> This shows that out of 34,678 bytes we needed, we wasted 6282, ~1.5
> pages. Since there are 5 modules, we waste about 1/3 page per module.
>
> So I don't, as you say; "... waste 1/2 page or more per module".
Somebody else posted their numbers: you waste about 15% of memory.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
