Hello!
> > Add documentation for new subnode properties, allowing bank configuration.
> > Based on u-boot implementation, but heavily reworked.
>
> Please, carefully look at:
> Documentation/devicetree/bindings/net/gpmc-eth.txt
> Documentation/devicetree/bindings/bus/ti-gpmc.txt
Thank you very much. Indeed, this looks very similar. By the way, should i
document smsc over sromc in the same manner, writing
devicetree/bindings/net/sromc-eth.txt?
This is a short reply for now, i'll make longer one (or just a new version)
after studying these existing bindings and trying to
apply them.
Pankaj:
> > +&sromc {
> > + pinctrl-names = "default";
> > + pinctrl-0 = <&srom_ctl>, <&srom_ebi>;
> > +
> > + ethernet@07000000 {
> > + compatible = "smsc,lan9115";
> > + reg = <0x07000000 0x10000>;
> > + phy-mode = "mii";
> > + interrupt-parent = <&gpx0>;
> > + interrupts = <5 8>;
> > + reg-io-width = <2>;
> > + smsc,irq-push-pull;
> > + smsc,force-internal-phy;
> > +
> > + samsung,srom-bank = <3>;
> > + samsung,srom-data-width = <2>;
> > + samsung,srom-timing = <1 9 12 1 9 1 1>;
>
> I think this is not correct. We can't change binding of "smsc,lan9115"
> which is already documented here [1]. These samsung specific srom
> properties should be in srom node or its subnode, but not in this way.
So, if you look at gpmc-eth.txt, you'll see that this approach is perfectly
valid (this is a reply to another msg, just don't want
to post one more single-line reply).
Kind regards,
Pavel Fedin
Expert Engineer
Samsung Electronics Research center Russia
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
