On 2015/12/14 13:46, Alexander Duyck wrote:
On Sun, Dec 13, 2015 at 9:22 PM, Yang Zhang <yang.zhang...@gmail.com> wrote:
On 2015/12/14 12:54, Alexander Duyck wrote:
On Sun, Dec 13, 2015 at 6:27 PM, Yang Zhang <yang.zhang...@gmail.com>
wrote:
On 2015/12/14 5:28, Alexander Duyck wrote:
This patch set is meant to be the guest side code for a proof of concept
involving leaving pass-through devices in the guest during the warm-up
phase of guest live migration. In order to accomplish this I have added
a
new function called dma_mark_dirty that will mark the pages associated
with
the DMA transaction as dirty in the case of either an unmap or a
sync_.*_for_cpu where the DMA direction is either DMA_FROM_DEVICE or
DMA_BIDIRECTIONAL. The pass-through device must still be removed before
the stop-and-copy phase, however allowing the device to be present
should
significantly improve the performance of the guest during the warm-up
period.
This current implementation is very preliminary and there are number of
items still missing. Specifically in order to make this a more complete
solution we need to support:
1. Notifying hypervisor that drivers are dirtying DMA pages received
2. Bypassing page dirtying when it is not needed.
Shouldn't current log dirty mechanism already cover them?
The guest has no way of currently knowing that the hypervisor is doing
dirty page logging, and the log dirty mechanism currently has no way
of tracking device DMA accesses. This change is meant to bridge the
two so that the guest device driver will force the SWIOTLB DMA API to
mark pages written to by the device as dirty.
OK. This is what we called "dummy write mechanism". Actually, this is just a
workaround before iommu dirty bit ready. Eventually, we need to change to
use the hardware dirty bit. Besides, we may still lost the data if dma
happens during/just before stop and copy phase.
Right, this is a "dummy write mechanism" in order to allow for entry
tracking. This only works completely if we force the hardware to
quiesce via a hot-plug event before we reach the stop-and-copy phase
of the migration.
The IOMMU dirty bit approach is likely going to have a significant
number of challenges involved. Looking over the driver and the data
sheet it looks like the current implementation is using a form of huge
pages in the IOMMU, as such we will need to tear that down and replace
it with 4K pages if we don't want to dirty large regions with each DMA
Yes, we need to split the huge page into small pages to get the small
dirty range.
transaction, and I'm not sure that is something we can change while
DMA is active to the affected regions. In addition the data sheet
what changes do you mean?
references the fact that the page table entries are stored in a
translation cache and in order to sync things up you have to
invalidate the entries. I'm not sure what the total overhead would be
for invalidating something like a half million 4K pages to migrate a
guest with just 2G of RAM, but I would think that might be a bit
Do you mean the cost of submit the flush request or the performance
impaction due to IOTLB miss? For the former, we have domain-selective
invalidation. For the latter, it would be acceptable since live
migration shouldn't last too long.
expensive given the fact that IOMMU accesses aren't known for being
incredibly fast when invalidating DMA on the host.
- Alex
--
best regards
yang
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
