[PATCH RFC 15/15] ARM: dts: sun9i: cubieboard4: Enable hardware reset and HS-DDR for eMMC

[Chen-Yu Tsai]

mmc2 has a special pin for eMMC hardware reset, which is controllable
from the controller. Add the "mmc-cap-hw-reset" property to denote that
this controller supports this function, and the pins are actually used.

Also increase the signal drive strength for mmc2 pins, for HS-DDR mode
support.

Signed-off-by: Chen-Yu Tsai <w...@csie.org>
---
 arch/arm/boot/dts/sun9i-a80-cubieboard4.dts | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts 
b/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts
index 382bd9fc5647..eb2ccd0a3bd5 100644
--- a/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts
+++ b/arch/arm/boot/dts/sun9i-a80-cubieboard4.dts
@@ -111,9 +111,15 @@
        vmmc-supply = <&reg_vcc3v0>;
        bus-width = <8>;
        non-removable;
+       cap-mmc-hw-reset;
        status = "okay";
 };
 
+&mmc2_8bit_pins {
+       /* Increase drive strength for DDR modes */
+       allwinner,drive = <SUN4I_PINCTRL_40_MA>;
+};
+
 &r_ir {
        status = "okay";
 };
-- 
2.7.0.rc3