On 16/02/16 16:10, Vladimir Murzin wrote:
> On 16/02/16 11:01, Arnd Bergmann wrote:
>> On Tuesday 16 February 2016 10:08:14 Vladimir Murzin wrote:
>>> +
>>> +       ethernet@40200000 {
>>> +               compatible = "smsc,lan9220", "smsc,lan9115";
>>> +               reg = <0x40200000 0x10000>;
>>> +               interrupts = <13>;
>>> +               interrupt-parent = <&nvic>;
>>> +               smsc,irq-active-high;
>>> +       };
>>> +};
>>> +
>>>
>>
>> This node seems slightly misplaced. Is there some external bus interface
>> that this is connected to? The address suggests that it should be somewhere
>> below the /soc node, and you probably want to list the external bus
>> interface with a "ranges" property that identifies the addresses visibile
>> there, and put the external chip under there.
>>
> 
> I might messed it up since the MAC/PHY connects to the same 16-bit
> interface as the 16MB PSRAM external memory and both connected via AHB.
> 
> Not sure how it should be expressed, so some help form DT camp would be
> appreciated.

Arnd,

Does following fixup address your point on where/how ethernet node
should be placed?

diff --git a/arch/arm/boot/dts/mps2-an385.dts b/arch/arm/boot/dts/an385.dts
index 976f86d..50c8d24 100644
--- a/arch/arm/boot/dts/mps2-an385.dts
+++ b/arch/arm/boot/dts/mps2-an385.dts
@@ -63,14 +63,10 @@
                device_type = "memory";
                reg = <0x21000000 0x1000000>;
        };
+};

-       ethernet@40200000 {
-               compatible = "smsc,lan9220", "smsc,lan9115";
-               reg = <0x40200000 0x10000>;
-               interrupts = <13>;
-               interrupt-parent = <&nvic>;
-               smsc,irq-active-high;
-       };
+&mb {
+       ranges = <0 0x40200000 0x10000>;
 };

 &uart0 {
diff --git a/arch/arm/boot/dts/mps2.dtsi b/arch/arm/boot/dts/mps2.dtsi
index 5d2c539..1673472 100644
--- a/arch/arm/boot/dts/mps2.dtsi
+++ b/arch/arm/boot/dts/mps2.dtsi
@@ -223,5 +223,21 @@
                                default-state = "off";
                        };
                };
+
+       };
+
+       mb: smb {
+               compatible = "simple-bus";
+               #address-cells = <1>;
+               #size-cells = <1>;
+               ranges;
+
+               ethernet@0 {
+                       compatible = "smsc,lan9220", "smsc,lan9115";
+                       reg = <0x0 0x10000>;
+                       interrupts = <13>;
+                       interrupt-parent = <&nvic>;
+                       smsc,irq-active-high;
+               };
        };
 };

Cheers
Vladimir

> 
> Cheers
> Vladimir
> 
>>      Arnd
>>
>>
>>
> 
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-ker...@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
> 
> 
> 

Reply via email to