On 14.03.2016 11:04, Chanwoo Choi wrote:
> This patch adds the MSHC2 (Mobile Storage Host Controller) Device Tree node
> for
> Exynos3250 SoC.
>
> Cc: Kukjin Kim <[email protected]>
> Cc: Krzysztof Kozlowski <[email protected]>
> Signed-off-by: Chanwoo Choi <[email protected]>
> Reviewed-by: Krzysztof Kozlowski <[email protected]>
> ---
> arch/arm/boot/dts/exynos3250-pinctrl.dtsi | 35
> +++++++++++++++++++++++++++++++
> arch/arm/boot/dts/exynos3250.dtsi | 13 ++++++++++++
> 2 files changed, 48 insertions(+)
After looking at your other patch ("ARM: dts: Add initial pin
configuration for exynos3250-rinato") I have doubts. The Monk will be
affected.
Here you are configuring all the gpk2 GPIOS for EMMC2 mode. Then on
Rinato you are setting it back to default non-used state. However the
Monk board will remain with this new configuration... so you would have
to add initial-state also for Monk.
But how about doing opposite? Configure here the pins to unused state
and enable them only for Artik board?
What do you think?
Best regards,
Krzysztof
