of_map_mode is needed so to be possible to set initial regulators mode from
the board DTS. Otherwise, for DT boot, regulators are left in their default
state after reset/reboot. Document device specific modes as well.
Signed-off-by: Ivaylo Dimitrov <ivo.g.dimitrov...@gmail.com>
---
.../bindings/regulator/twl-regulator.txt | 6 ++++++
drivers/regulator/twl-regulator.c | 22 +++++++++++++++++++---
2 files changed, 25 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/regulator/twl-regulator.txt
b/Documentation/devicetree/bindings/regulator/twl-regulator.txt
index 75b0c16..74a91c4 100644
--- a/Documentation/devicetree/bindings/regulator/twl-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/twl-regulator.txt
@@ -57,6 +57,12 @@ For twl4030 regulators/LDOs
Optional properties:
- Any optional property defined in bindings/regulator/regulator.txt
+For twl4030 regulators/LDOs:
+ - regulator-initial-mode:
+ - 0x08 - Sleep mode, the nominal output voltage is maintained with low power
+ consumption with low load current capability.
+ - 0x0e - Active mode, the regulator can deliver its nominal output voltage
+ with full-load current capability.
Example:
diff --git a/drivers/regulator/twl-regulator.c
b/drivers/regulator/twl-regulator.c
index aad748b0..53fcbb0 100644
--- a/drivers/regulator/twl-regulator.c
+++ b/drivers/regulator/twl-regulator.c
@@ -395,6 +395,18 @@ static int twl4030reg_set_mode(struct regulator_dev *rdev,
unsigned mode)
return twl4030_send_pb_msg(message);
}
+static inline unsigned int twl4030reg_map_mode(unsigned int mode)
+{
+ switch (mode) {
+ case RES_STATE_ACTIVE:
+ return REGULATOR_MODE_NORMAL;
+ case RES_STATE_SLEEP:
+ return REGULATOR_MODE_STANDBY;
+ default:
+ return -EINVAL;
+ }
+}
+
static int twl6030reg_set_mode(struct regulator_dev *rdev, unsigned mode)
{
struct twlreg_info *info = rdev_get_drvdata(rdev);
@@ -897,10 +909,11 @@ static struct regulator_ops twlsmps_ops = {
#define TWL4030_FIXED_LDO(label, offset, mVolts, num, turnon_delay, \
remap_conf) \
TWL_FIXED_LDO(label, offset, mVolts, num, turnon_delay, \
- remap_conf, TWL4030, twl4030fixed_ops)
+ remap_conf, TWL4030, twl4030fixed_ops, \
+ twl4030reg_map_mode)
#define TWL6030_FIXED_LDO(label, offset, mVolts, turnon_delay) \
TWL_FIXED_LDO(label, offset, mVolts, 0x0, turnon_delay, \
- 0x0, TWL6030, twl6030fixed_ops)
+ 0x0, TWL6030, twl6030fixed_ops, 0x0)
#define TWL4030_ADJUSTABLE_LDO(label, offset, num, turnon_delay, remap_conf) \
static const struct twlreg_info TWL4030_INFO_##label = { \
@@ -917,6 +930,7 @@ static const struct twlreg_info TWL4030_INFO_##label = { \
.type = REGULATOR_VOLTAGE, \
.owner = THIS_MODULE, \
.enable_time = turnon_delay, \
+ .of_map_mode = twl4030reg_map_mode, \
}, \
}
@@ -932,6 +946,7 @@ static const struct twlreg_info TWL4030_INFO_##label = { \
.type = REGULATOR_VOLTAGE, \
.owner = THIS_MODULE, \
.enable_time = turnon_delay, \
+ .of_map_mode = twl4030reg_map_mode, \
}, \
}
@@ -977,7 +992,7 @@ static const struct twlreg_info TWL6032_INFO_##label = { \
}
#define TWL_FIXED_LDO(label, offset, mVolts, num, turnon_delay, remap_conf, \
- family, operations) \
+ family, operations, map_mode) \
static const struct twlreg_info TWLFIXED_INFO_##label = { \
.base = offset, \
.id = num, \
@@ -992,6 +1007,7 @@ static const struct twlreg_info TWLFIXED_INFO_##label = { \
.owner = THIS_MODULE, \
.min_uV = mVolts * 1000, \
.enable_time = turnon_delay, \
+ .of_map_mode = map_mode, \
}, \
}
--
1.9.1
