On 04/27/2016 09:33 AM, Appana Durga Kedareswara Rao wrote: > Hi Lars, > >> -----Original Message----- >> From: Lars-Peter Clausen [mailto:[email protected]] >> Sent: Wednesday, April 27, 2016 12:42 PM >> To: Appana Durga Kedareswara Rao <[email protected]>; >> [email protected]; [email protected]; [email protected]; >> [email protected]; [email protected]; Michal Simek >> <[email protected]>; Soren Brinkmann <[email protected]>; >> [email protected]; [email protected]; Appana Durga Kedareswara >> Rao <[email protected]>; [email protected]; >> [email protected]; [email protected]; Anirudha >> Sarangi <[email protected]>; Punnaiah Choudary Kalluri >> <[email protected]> >> Cc: [email protected]; [email protected]; linux- >> [email protected]; [email protected] >> Subject: Re: [PATCH v7 1/2] Documentation: DT: dma: Add Xilinx zynqmp dma >> device tree binding documentation >> >> On 04/27/2016 09:05 AM, Kedareswara rao Appana wrote: >> [...] >>> +- xlnx,include-sg : Indicates the controller to operate in simple or >>> + scatter gather dma mode >>> +- xlnx,ratectrl : Scheduling interval in terms of clock cycles >>> for >>> + source AXI transaction >>> +- xlnx,overfetch : Tells whether the channel is allowed to over >>> + fetch the data >>> +- xlnx,src-issue : Number of AXI outstanding transactions on source >> side >>> +- xlnx,src-burst-len : AXI length for data read. Support only power >>> of >>> + 2 byte values. >>> +- xlnx,dst-burst-len : AXI length for data write. Support only power >>> of >> >> These are all software runtime configuration parameters that you'd want to >> change at runtime depending on which peripheral you are targeting with a >> specific DMA transfer. These really do not belong into the devicetree. > > You mean to have a separate config structure in the driver and handle the > above parameters > Through that structure??? > > I understand that above will work for slave dma transfer types what about > memory to memory > Transfers where we don't have provision to the use this parameters...
These parameters are just as application specific as e.g. the DMA source/destination address or the DMA transfer length. If you want to use the DMA controller in a different configuration you'd have to re-compile the DTB and reboot your board, that is not really practical. Especially considering that you'd typically have multiple applications using the DMA controller in different configurations concurrently. In general if I have to reconfigure the DT depending on what application software is running something is fundamentally broken. Derive these parameters at runtime depending on the requested transfer. E.g. some transfer types only work in SG mode, others only work in non-SG modes. For those which can work in both modes choose the one that is more efficient. Similar for the other parameters. - Lars
