These divide off of PLLD_PER and are used for the ethernet and wifi
PHYs source PLLs. Neither of them is currently represented by a phy
device that would grab the clock for us.
This keeps other drivers from killing the networking PHYs when they
disable their own clocks and trigger PLLD_PER's refcount going to 0.
Signed-off-by: Eric Anholt <e...@anholt.net>
---
v3: Only mark critical if it's on at boot.
drivers/clk/bcm/clk-bcm2835.c | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/drivers/clk/bcm/clk-bcm2835.c b/drivers/clk/bcm/clk-bcm2835.c
index d9db03cb3fd8..400615baea97 100644
--- a/drivers/clk/bcm/clk-bcm2835.c
+++ b/drivers/clk/bcm/clk-bcm2835.c
@@ -1239,6 +1239,12 @@ static struct clk *bcm2835_register_clock(struct
bcm2835_cprman *cprman,
} else {
init.ops = &bcm2835_clock_clk_ops;
init.flags |= CLK_SET_RATE_GATE | CLK_SET_PARENT_GATE;
+
+ /* If the clock wasn't actually enabled at boot, it's not
+ * critical.
+ */
+ if (!(cprman_read(cprman, data->ctl_reg) & CM_ENABLE))
+ init.flags &= ~CLK_IS_CRITICAL;
}
clock = devm_kzalloc(cprman->dev, sizeof(*clock), GFP_KERNEL);
@@ -1708,13 +1714,15 @@ static const struct bcm2835_clk_desc clk_desc_array[] =
{
.div_reg = CM_GP1DIV,
.int_bits = 12,
.frac_bits = 12,
+ .flags = CLK_IS_CRITICAL,
.is_mash_clock = true),
[BCM2835_CLOCK_GP2] = REGISTER_PER_CLK(
.name = "gp2",
.ctl_reg = CM_GP2CTL,
.div_reg = CM_GP2DIV,
.int_bits = 12,
- .frac_bits = 12),
+ .frac_bits = 12,
+ .flags = CLK_IS_CRITICAL),
/* HDMI state machine */
[BCM2835_CLOCK_HSM] = REGISTER_PER_CLK(
--
2.8.0.rc3
