On Tuesday 09 August 2016 10:45 PM, Karl Beldan wrote:
> Currently the davinci da8xx boards use the mach-davinci aemif code.
> Instantiating an aemif node into the DT allows to use the ti-aemif
> memory driver and is another step to better DT support.
> Also it will allow to properly pass the emif timings via DT.
>
> Signed-off-by: Karl Beldan <kbel...@baylibre.com>
> ---
> arch/arm/boot/dts/da850.dtsi | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi
> index bc10e7e..f62928c 100644
> --- a/arch/arm/boot/dts/da850.dtsi
> +++ b/arch/arm/boot/dts/da850.dtsi
> @@ -411,6 +411,16 @@
> dma-names = "tx", "rx";
> };
> };
> + aemif: aemif@68000000 {
> + compatible = "ti,da850-aemif";
> + #address-cells = <2>;
> + #size-cells = <1>;
> +
> + reg = <0x68000000 0x00008000>;
> + ranges = <0 0 0x60000000 0x08000000
> + 1 0 0x68000000 0x00008000>;
> + status = "disabled";
> + };
> nand_cs3@62000000 {
> compatible = "ti,davinci-nand";
> reg = <0x62000000 0x807ff
The nand node should be part of aemif node like it is done for keystone
boards.
Regards,
Sekhar
