On Thu, 9 Nov 2000, Ivan Kokshaysky wrote:
Hmmm...
The PCI spec. says that Limit registers define the top addresses
_inclusive_.
The spec. does not seem to imagine that a Limit register lower than the
corresponding Base register will ever exist anywhere, in my opinion. :-)
This let me think that trying to be clever here is probably a very bad
idea. What is so catastrophic of having 1 to 4 bytes of addresses and no
more being possibly in a forwardable range?
Gérard.
> On Wed, Nov 08, 2000 at 03:48:11PM -0800, Richard Henderson wrote:
> > Whee! We're back in Bootsville.
>
> Cool!
> Meanwhile this base/limit stuff got confirmation :-)
> Here is a patch against bridges-2.4.0t11-rth.
>
> Ivan.
>
> --- 2.4.0t11p1/drivers/pci/setup-bus.c Wed Nov 8 19:44:42 2000
> +++ linux/drivers/pci/setup-bus.c Thu Nov 9 15:11:01 2000
> @@ -88,14 +88,14 @@ pbus_assign_resources_sorted(struct pci_
> ranges->io_end += io_reserved;
> ranges->mem_end += mem_reserved;
>
> - /* ??? How to turn off a bus from responding to, say, I/O at
> - all if there are no I/O ports behind the bus? Turning off
> - PCI_COMMAND_IO doesn't seem to do the job. So we must
> - allow for at least one unit. */
> - if (ranges->io_end == ranges->io_start)
> - ranges->io_end += 1;
> - if (ranges->mem_end == ranges->mem_start)
> - ranges->mem_end += 1;
> + /* Interesting case is when, say, io_end == io_start, i.e.
> + there is no I/O behind the bridge at all. We initialize
> + the bridge with base=io_start and limit=io_end-1, so
> + in this case we'll have base > limit. According to
> + the `PCI-to-PCI Bridge Architecture Specification', this
> + means that the bridge will not forward any I/O transactions
> + from the primary bus to the secondary bus and will forward
> + all I/O transactions upstream. Exactly what we want. */
>
> ranges->io_end = ROUND_UP(ranges->io_end, 4*1024);
> ranges->mem_end = ROUND_UP(ranges->mem_end, 1024*1024);
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to [EMAIL PROTECTED]
> Please read the FAQ at http://www.tux.org/lkml/
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
