Hi Joshua,

looks good to me; however, I think since you're adding initial support,
I'd squash this together with [3/5].

On Fri, Oct 28, 2016 at 09:56:42AM -0700, Joshua Clayton wrote:
> The status pin may not show ready in the time described in the
> Altetera manual. check the value several times before giving up

s/Altetera/Altera
> For the hardware I am working on, the status pin takes 250 us,
> 5 times as long as described by Altera.
> 
> Signed-off-by: Joshua Clayton <stillcompil...@gmail.com>
> ---
>  drivers/fpga/cyclone-ps-spi.c | 13 ++++++++-----
>  1 file changed, 8 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/fpga/cyclone-ps-spi.c b/drivers/fpga/cyclone-ps-spi.c
> index 4b70d5c..c368223 100644
> --- a/drivers/fpga/cyclone-ps-spi.c
> +++ b/drivers/fpga/cyclone-ps-spi.c
> @@ -20,6 +20,7 @@
>  
>  #define FPGA_RESET_TIME              50   /* time in usecs to trigger FPGA 
> config */
> -#define FPGA_MIN_DELAY               250  /* min usecs to wait for config 
> status */
> +#define FPGA_MIN_DELAY               50   /* min usecs to wait for config 
> status */
> +#define FPGA_MAX_DELAY               1000 /* max usecs to wait for config 
> status */
>  
>  struct cyclonespi_conf {
>       struct gpio_desc *config;
> @@ -42,6 +43,7 @@ static int cyclonespi_write_init(struct fpga_manager *mgr, 
> u32 flags,
>                                const char *buf, size_t count)
>  {
>       struct cyclonespi_conf *conf = (struct cyclonespi_conf *)mgr->priv;
> +     int i;
>  
>       if (flags & FPGA_MGR_PARTIAL_RECONFIG) {
>               dev_err(&mgr->dev, "Partial reconfiguration not supported.\n");
> @@ -56,13 +58,14 @@ static int cyclonespi_write_init(struct fpga_manager 
> *mgr, u32 flags,
>       }
>  
>       gpiod_set_value(conf->config, 1);
> -     usleep_range(FPGA_MIN_DELAY, FPGA_MIN_DELAY + 20);
> -     if (gpiod_get_value(conf->status) == 0) {
> -             dev_err(&mgr->dev, "Status pin not ready.\n");
> -             return -EIO;
> +     for (i = 0; i < (FPGA_MAX_DELAY / FPGA_MIN_DELAY); i++) {
> +             usleep_range(FPGA_MIN_DELAY, FPGA_MIN_DELAY + 20);
> +             if (gpiod_get_value(conf->status))
> +                     return 0;
>       }
>  
> -     return 0;
> +     dev_err(&mgr->dev, "Status pin not ready.\n");
> +     return -EIO;
>  }
>  
>  static void rev_buf(void *buf, size_t len)
> -- 
> 2.7.4
> 

Cheers,

Moritz

Reply via email to