On Thu, Jan 12, 2017 at 03:10:25PM +0100, Christian Borntraeger wrote: > On 01/10/2017 01:56 PM, Christian Borntraeger wrote: > > On 01/10/2017 01:36 PM, Gonglei (Arei) wrote: > >> Hi, > >> > >>> > >>> On 12/15/2016 03:03 AM, Gonglei wrote: > >>> [...] > >>>> + > >>>> +static struct crypto_alg virtio_crypto_algs[] = { { > >>>> + .cra_name = "cbc(aes)", > >>>> + .cra_driver_name = "virtio_crypto_aes_cbc", > >>>> + .cra_priority = 501, > >>> > >>> > >>> This is still higher than the hardware-accelerators (like intel aesni or > >>> the > >>> s390 cpacf functions or the arm hw). aesni and s390/cpacf are supported > >>> by the > >>> hardware virtualization and available to the guests. I do not see a way > >>> how > >>> virtio > >>> crypto can be faster than that (in the end it might be cpacf/aesni + > >>> overhead) > >>> instead it will very likely be slower. > >>> So we should use a number that is higher than software implementations but > >>> lower than the hw ones. > >>> > >>> Just grepping around, the software ones seem be be around 100 and the > >>> hardware > >>> ones around 200-400. So why was 150 not enough? > >>> > >> I didn't find a documentation about how we use the priority, and I assumed > >> people use virtio-crypto will configure hardware accelerators in the > >> host. So I choosed the number which bigger than aesni's priority. > > > > Yes, but the aesni driver will only bind if there is HW support in the > > guest. > > And if aesni is available in the guest (or the s390 aes function from cpacf) > > it will always be faster than the same in the host via virtio.So your > > priority > > should be smaller. > > > any opinion on this?
Going forward, we might add an emulated aesni device and that might become slower than virtio. OTOH if or when this happens, we can solve it by adding a priority or a feature flag to virtio to raise its priority. So I think I agree with Christian here, let's lower the priority. Gonglei, could you send a patch like this? -- MST