On 07/19/2017 05:17 PM, Abhishek Sahu wrote:
The configuration for BCH is not correct in the current driver.
The ECC_CFG_ECC_DISABLE bit defines whether to enable or disable the
BCH ECC in which
0x1 : BCH_DISABLED
0x0 : BCH_ENABLED
But currently host->bch_enabled is being assined to BCH_DISABLED.
s/assined/assigned
Thanks for fixing this up.
Reviewed-by: Archit Taneja <arch...@codeaurora.org>
Fixes: c76b78d8ec05a ("mtd: nand: Qualcomm NAND controller driver")
Cc: sta...@vger.kernel.org
Signed-off-by: Abhishek Sahu <abs...@codeaurora.org>
---
drivers/mtd/nand/qcom_nandc.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
index 57d483a..bc0408c 100644
--- a/drivers/mtd/nand/qcom_nandc.c
+++ b/drivers/mtd/nand/qcom_nandc.c
@@ -1,5 +1,5 @@
/*
- * Copyright (c) 2016, The Linux Foundation. All rights reserved.
+ * Copyright (c) 2016-2017, The Linux Foundation. All rights reserved.
*
* This software is licensed under the terms of the GNU General Public
* License version 2, as published by the Free Software Foundation, and
@@ -1893,7 +1893,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host
*host)
| wide_bus << WIDE_FLASH
| 1 << DEV0_CFG1_ECC_DISABLE;
- host->ecc_bch_cfg = host->bch_enabled << ECC_CFG_ECC_DISABLE
+ host->ecc_bch_cfg = !host->bch_enabled << ECC_CFG_ECC_DISABLE
| 0 << ECC_SW_RESET
| host->cw_data << ECC_NUM_DATA_BYTES
| 1 << ECC_FORCE_CLK_OPEN
--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
