The mt8173-mtu3.txt actually holds the bindings for all mediatek
SoCs with usb3 DRD IP, so add a generic compatible and change the
name to mtu3.txt.
Signed-off-by: Chunfeng Yun <chunfeng....@mediatek.com>
---
.../bindings/usb/{mt8173-mtu3.txt => mtu3.txt} | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
rename Documentation/devicetree/bindings/usb/{mt8173-mtu3.txt => mtu3.txt}
(95%)
diff --git a/Documentation/devicetree/bindings/usb/mt8173-mtu3.txt
b/Documentation/devicetree/bindings/usb/mtu3.txt
similarity index 95%
rename from Documentation/devicetree/bindings/usb/mt8173-mtu3.txt
rename to Documentation/devicetree/bindings/usb/mtu3.txt
index 1d7c3bc..832741d 100644
--- a/Documentation/devicetree/bindings/usb/mt8173-mtu3.txt
+++ b/Documentation/devicetree/bindings/usb/mtu3.txt
@@ -1,7 +1,9 @@
The device node for Mediatek USB3.0 DRD controller
Required properties:
- - compatible : should be "mediatek,mt8173-mtu3"
+ - compatible : should be one of
+ "mediatek,mt8173-mtu3" (deprecated, use "mediatek,mtu3" instead),
+ "mediatek,mtu3"
- reg : specifies physical base address and size of the registers
- reg-names: should be "mac" for device IP and "ippc" for IP port control
- interrupts : interrupt used by the device IP
@@ -44,7 +46,7 @@ Optional properties:
Sub-nodes:
The xhci should be added as subnode to mtu3 as shown in the following example
if host mode is enabled. The DT binding details of xhci can be found in:
-Documentation/devicetree/bindings/usb/mt8173-xhci.txt
+Documentation/devicetree/bindings/usb/xhci-mtk.txt
Example:
ssusb: usb@11271000 {
--
1.7.9.5
