[PATCH 1/3] ARM: dts: at91: sama5d27_som1_ek: update pinmux/pinconf for LEDs and USB

[Claudiu Beznea]

From: Ludovic Desroches <ludovic.desroc...@microchip.com>

There are some changes from the prototype board concerning LEDs and USB
pins:
- USBB power enable and red LED pins are inverted.
- The polarity of LEDs is inverted too.

Signed-off-by: Ludovic Desroches <ludovic.desroc...@microchip.com>
Signed-off-by: Claudiu Beznea <claudiu.bez...@microchip.com>
---
 arch/arm/boot/dts/at91-sama5d27_som1_ek.dts | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/arch/arm/boot/dts/at91-sama5d27_som1_ek.dts 
b/arch/arm/boot/dts/at91-sama5d27_som1_ek.dts
index 9c9088c99cc4..f13ef4fbab60 100644
--- a/arch/arm/boot/dts/at91-sama5d27_som1_ek.dts
+++ b/arch/arm/boot/dts/at91-sama5d27_som1_ek.dts
@@ -67,7 +67,7 @@
 
                usb1: ohci@00400000 {
                        num-ports = <3>;
-                       atmel,vbus-gpio = <&pioA PIN_PA10 GPIO_ACTIVE_HIGH>;
+                       atmel,vbus-gpio = <&pioA PIN_PA27 GPIO_ACTIVE_HIGH>;
                        pinctrl-names = "default";
                        pinctrl-0 = <&pinctrl_usb_default>;
                        status = "okay";
@@ -330,7 +330,7 @@
                                };
 
                                pinctrl_led_gpio_default: led_gpio_default {
-                                       pinmux = <PIN_PA27__GPIO>,
+                                       pinmux = <PIN_PA10__GPIO>,
                                                 <PIN_PB1__GPIO>,
                                                 <PIN_PA31__GPIO>;
                                        bias-pull-up;
@@ -396,7 +396,7 @@
                                };
 
                                pinctrl_usb_default: usb_default {
-                                       pinmux = <PIN_PA10__GPIO>,
+                                       pinmux = <PIN_PA27__GPIO>,
                                                 <PIN_PD19__GPIO>;
                                        bias-disable;
                                };
@@ -520,17 +520,17 @@
 
                red {
                        label = "red";
-                       gpios = <&pioA PIN_PA27 GPIO_ACTIVE_LOW>;
+                       gpios = <&pioA PIN_PA10 GPIO_ACTIVE_HIGH>;
                };
 
                green {
                        label = "green";
-                       gpios = <&pioA PIN_PB1 GPIO_ACTIVE_LOW>;
+                       gpios = <&pioA PIN_PB1 GPIO_ACTIVE_HIGH>;
                };
 
                blue {
                        label = "blue";
-                       gpios = <&pioA PIN_PA31 GPIO_ACTIVE_LOW>;
+                       gpios = <&pioA PIN_PA31 GPIO_ACTIVE_HIGH>;
                        linux,default-trigger = "heartbeat";
                };
        };
-- 
2.7.4