[PATCH v2 11/14] ARM: dts: at91: sama5d2_xplained: remove pull-up on SD/MMC lines

[Claudiu Beznea]

From: Nicolas Ferre <nicolas.fe...@microchip.com>

As the board have the proper pull-ups soldered on the data and CMD
lines we don't need them specified in the PADs. So remove the
"bias-pull-up" property and set "bias-disable".
This will also save some power.

Signed-off-by: Nicolas Ferre <nicolas.fe...@microchip.com>
[claudiu.bez...@microchip.com: change subject to match the desired prefix]
Signed-off-by: Claudiu Beznea <claudiu.bez...@microchip.com>
---
 arch/arm/boot/dts/at91-sama5d2_xplained.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts 
b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
index 851a095fd51d..62328310ef42 100644
--- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
@@ -437,7 +437,7 @@
                                                         <PIN_PA7__SDMMC0_DAT5>,
                                                         <PIN_PA8__SDMMC0_DAT6>,
                                                         <PIN_PA9__SDMMC0_DAT7>;
-                                               bias-pull-up;
+                                               bias-disable;
                                        };
 
                                        ck_cd_rstn_vddsel {
@@ -456,7 +456,7 @@
                                                         
<PIN_PA19__SDMMC1_DAT1>,
                                                         
<PIN_PA20__SDMMC1_DAT2>,
                                                         
<PIN_PA21__SDMMC1_DAT3>;
-                                               bias-pull-up;
+                                               bias-disable;
                                        };
 
                                        conf-ck_cd {
-- 
2.7.4