On Tue, 2018-02-27 at 10:07 +0800, Yong Deng wrote: > Add binding documentation for Allwinner V3s CSI. > > Acked-by: Maxime Ripard <maxime.rip...@free-electrons.com> > Acked-by: Sakari Ailus <sakari.ai...@linux.intel.com> > Reviewed-by: Rob Herring <r...@kernel.org> > Signed-off-by: Yong Deng <yong.d...@magewell.com> > --- > .../devicetree/bindings/media/sun6i-csi.txt | 59 > ++++++++++++++++++++++ > 1 file changed, 59 insertions(+) > create mode 100644 Documentation/devicetree/bindings/media/sun6i-csi.txt > > diff --git a/Documentation/devicetree/bindings/media/sun6i-csi.txt > b/Documentation/devicetree/bindings/media/sun6i-csi.txt > new file mode 100644 > index 000000000000..2ff47a9507a6 > --- /dev/null > +++ b/Documentation/devicetree/bindings/media/sun6i-csi.txt > @@ -0,0 +1,59 @@ > +Allwinner V3s Camera Sensor Interface > +------------------------------------- > + > +Allwinner V3s SoC features two CSI module. CSI0 is used for MIPI CSI-2 > +interface and CSI1 is used for parallel interface. > + > +Required properties: > + - compatible: value must be "allwinner,sun8i-v3s-csi" > + - reg: base address and size of the memory-mapped region. > + - interrupts: interrupt associated to this IP > + - clocks: phandles to the clocks feeding the CSI > + * bus: the CSI interface clock > + * mod: the CSI module clock > + * ram: the CSI DRAM clock > + - clock-names: the clock names mentioned above > + - resets: phandles to the reset line driving the CSI > + > +Each CSI node should contain one 'port' child node with one child 'endpoint' > +node, according to the bindings defined in > +Documentation/devicetree/bindings/media/video-interfaces.txt. As mentioned > +above, the endpoint's bus type should be MIPI CSI-2 for CSI0 and parallel or > +Bt656 for CSI1. > + > +Endpoint node properties for CSI1 > +--------------------------------- > + > +- remote-endpoint : (required) a phandle to the bus receiver's endpoint > + node > +- bus-width: : (required) must be 8, 10, 12 or 16 > +- pclk-sample : (optional) (default: sample on falling edge)
It would be helpful to state that 1 is rising edge and 0 is falling edge, see for example ov5640.txt regards Philipp
