On Thu, 2018-03-29 at 15:07 +0900, Masahiro Yamada wrote: > This driver handles the reset control in a common manner; deassert > resets before use, assert them after use. There is no good reason > why it should be exclusive.
Is this preemptive cleanup, or do you have hardware on the horizon that shares these reset lines with other peripherals? > Also, use devm_ for clean-up. > > Signed-off-by: Masahiro Yamada <yamada.masah...@socionext.com> > --- > > CCing Philipp Zabel. > I see his sob in commit 06c47e6286d5. At the time I was concerned with the reset_control_array addition and didn't look closely at the exclusive vs shared issue. > drivers/usb/dwc3/dwc3-of-simple.c | 7 ++----- > 1 file changed, 2 insertions(+), 5 deletions(-) > > diff --git a/drivers/usb/dwc3/dwc3-of-simple.c > b/drivers/usb/dwc3/dwc3-of-simple.c > index e54c362..bd6ab65 100644 > --- a/drivers/usb/dwc3/dwc3-of-simple.c > +++ b/drivers/usb/dwc3/dwc3-of-simple.c > @@ -91,7 +91,7 @@ static int dwc3_of_simple_probe(struct platform_device > *pdev) > platform_set_drvdata(pdev, simple); > simple->dev = dev; > > - simple->resets = of_reset_control_array_get_optional_exclusive(np); > + simple->resets = devm_reset_control_array_get_optional_shared(dev); >From the usage in the driver, it does indeed look like _shared reset usage is appropriate. I assume that the hardware has no need for the reset to be asserted right before probe or after remove, it just requires that the reset line is kept deasserted while the driver is probed. > if (IS_ERR(simple->resets)) { > ret = PTR_ERR(simple->resets); > dev_err(dev, "failed to get device resets, err=%d\n", ret); > @@ -100,7 +100,7 @@ static int dwc3_of_simple_probe(struct platform_device > *pdev) > > ret = reset_control_deassert(simple->resets); > if (ret) > - goto err_resetc_put; > + return ret; > > ret = dwc3_of_simple_clk_init(simple, of_count_phandle_with_args(np, > "clocks", "#clock-cells")); > @@ -126,8 +126,6 @@ static int dwc3_of_simple_probe(struct platform_device > *pdev) > err_resetc_assert: > reset_control_assert(simple->resets); > > -err_resetc_put: > - reset_control_put(simple->resets); > return ret; > } > > @@ -146,7 +144,6 @@ static int dwc3_of_simple_remove(struct platform_device > *pdev) > simple->num_clocks = 0; > > reset_control_assert(simple->resets); > - reset_control_put(simple->resets); > > pm_runtime_put_sync(dev); > pm_runtime_disable(dev); Changing to devm_ changes the order here. Whether or not it could be a problem to assert the reset only after pm_runtime_put (or potentially never), I can't say. I assume this is a non-issue, but somebody who knows the hardware better would have to decide. regards Philipp