On 13/04/2018 19:11:16+0300, Radu Pirea wrote:
> These are bindings for at91-usart IP in spi spi mode. There is no support for
> internal chip select. Only kind of chip selects available are gpio chip
> selects.
>
> Signed-off-by: Radu Pirea <radu.pi...@microchip.com>
> ---
> .../bindings/spi/microchip,at91-usart-spi.txt | 24 +++++++++++++++++++
> 1 file changed, 24 insertions(+)
> create mode 100644
> Documentation/devicetree/bindings/spi/microchip,at91-usart-spi.txt
>
> diff --git
> a/Documentation/devicetree/bindings/spi/microchip,at91-usart-spi.txt
> b/Documentation/devicetree/bindings/spi/microchip,at91-usart-spi.txt
> new file mode 100644
> index 000000000000..92d33ccdffae
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/spi/microchip,at91-usart-spi.txt
> @@ -0,0 +1,24 @@
> +* Universal Synchronous Asynchronous Receiver/Transmitter (USART) in SPI mode
> +
> +Required properties:
> +- #size-cells : Must be <0>
> +- #address-cells : Must be <1>
> +- compatible: Should be "microchip,at91sam9g45-usart-spi" or
> "microchip,sama5d2-usart-spi"
> +- reg: Should contain registers location and length
> +- interrupts: Should contain interrupt
> +- clocks: phandles to input clocks.
> +- clock-names: tuple listing input clock names.
> + Required elements: "usart"
> +- cs-gpios: chipselects (internal cs not supported)
> +
> +Example:
> + spi0: spi@f001c000 {
> + #address-cells = <1>;
> + #size-cells = <0>;
> + compatible = "microchip,sama5d2-usart-spi",
> "microchip,at91sam9g45-usart-spi";
I'm pretty sure this will be considered configuration rather than
hardware description. Why don't you do something like the flexcom mode
selection?
> + reg = <0xf001c000 0x100>;
> + interrupts = <12 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&usart0_clk>;
> + clock-names = "usart";
> + cs-gpios = <&pioB 3 0>;
> + };
> --
> 2.17.0
>
--
Alexandre Belloni, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com
