On 30 May 2018 at 20:53, Dan Streetman <[email protected]> wrote: > On Wed, May 30, 2018 at 6:39 AM, Li Wang <[email protected]> wrote: >> The '/sys/../zswap/stored_pages:' keep raising in zswap test with >> "zswap.max_pool_percent=0" parameter. But theoretically, it should >> not compress or store pages any more since there is no space in >> compressed pool. >> >> Reproduce steps: >> 1. Boot kernel with "zswap.enabled=1" >> 2. Set the max_pool_percent to 0 >> # echo 0 > /sys/module/zswap/parameters/max_pool_percent >> 3. Do memory stress test to see if some pages have been compressed >> # stress --vm 1 --vm-bytes $mem_available"M" --timeout 60s >> 4. Watching the 'stored_pages' number increasing or not >> >> The root cause is: >> When zswap_max_pool_percent is setting to 0 via kernel parameter, the >> zswap_is_full() will always return true to do zswap_shrink(). But if >> the shinking is able to reclain a page successful, then proceeds to >> compress/store another page, so the value of stored_pages will keep >> changing. >> >> To solve the issue, this patch adds zswap_is_full() check again after >> zswap_shrink() to make sure it's now under the max_pool_percent, and >> not to compress/store if reach its limitaion. >> >> Signed-off-by: Li Wang <[email protected]> > > Acked-by: Dan Streetman <[email protected]>
ping~ Any possible to merge this in kernel-4.18-rcX? My zswap test always fails on the upstream kernel. -- Regards, Li Wang Email: [email protected]
